Sample holders

…it is necessary that all sample holders used in the Imaging station are standardized. Users are required to mount their samples on OMNY pins. The NanoMAX team can provide pointy…

Access modes

Below are the access modes the FinEstBeAMS beamline participates in, and potentially useful notes regarding what is offered for each: Standard access chevron_right The standard peer reviewed access mode at…

Staff

The Design Office team consists of the following people Design Office Common contact Office location: D110053 E-mail: mechanical@maxiv.lu.se Joaquin Gonzalez E-mail: joaquin.gonzalez@maxiv.lu.se Phone: +46462226511 Linus Roslund Mechanical designer Office location:…

High-Temperature Cell

…time-resolved APXPS using please the HT cell, please, check Time-resolved APXPS page. Purpose To enable photoemission measurements at mbar pressures and up to 1000 C Description Small volume (1 L)…

A record year for research at MAX IV

…users. 40,250 hours of used beamtime.  +31% beamtime hours awarded to academic users through Open Calls.   14% of the beamtime connected with industry research.  834 paid proprietary beamtime hours.  64%…

Experimental station

…the beam is performed using the ‘Beam Conditioning Unit’ (BCU) located at the upstream end of the experimental hutch. This unit is placed on a large granite block for increased

Microscope

…of this image. Right panel: height profile along the indicated line. Comparison between STM and ncAFM imaging/resolution Sample: SiC(0001), STM: Vbias = +1.25 V, It = 230 pA AFM: Vbias…

Technical Infrastructure

The Technical Infrastructure team is part of Engineering II and is in charge of Cooling, Ventilation, Compressed air, Cryo and gas systems. The team supports the entire MAX IV laboratory…

Workshop: Industrial utilisation of MAX IV

…materials research as part of a recently completed project funded by Vetenskapsrådet (DNR: 2018-06378). The project has focused on tackling challenges that limit the industrial use of these types of…