HIPPIE Overview

Photon energy250 eV - 2400 eV (maximum range)
300 eV - 2000 eV at > 1012 ph/s
Resolving powerUp to 35000
Spot size60 µm (h) x 25 µm (v)
AnalyserScienta Hipp-3 with SWIFT acceleration mode
Catalysis cellNormally up to 10 mbar
Laser heating to to 600 C
Gas mixing panel (up to 8 gases)
Mass spectroscopy of gas sampled at cell input, output or analyzer.
Electrochemical/liquid cellUp to 30 mbar
Solid-liquid interfaces via dip and pull
Liquid-gas interfaces via liquid jet

See the Beamline Optics and Experimental Station pages for more information.

 

APXPS proposal submission

As there are two complimentary APXPS beamlines at MAX IV, many proposals could be carried out at either HIPPIE or SPECIES. Such proposals can therefore be submitted with a preference of beamline, which is recommended if a proposal would benifit from specific capabilities of either beamline (e.g. photon or sample environment requirements), or without a preference in which case the proposal will be considered for both beamlines.

 

Scanning probe microscopy

If your experiment would benefit from UHV scanning probe microscopy (STM or NC-AFM) of your surfaces, samples from HIPPIE can be transferred via vacuum suitcase to an Omicron VT SPM. For more information, refer to the Scanning Probe Microscopy lab webpages.

 

HIPPIE sample requirements

HIPPIE uses slightly custom “flag” style sample plates. These can have a hole in the plate to allow for direct heating of the sample via an infrared laser and a thermocouple electrical contacts for direct measurement of the sample temperature. Samples are typically mounted on the plates using clips, that can either be attached to the plate by spot welding or screws. Typically, samples are approximately 8 x 8 mm, with a maximum size of 10 x 10 mm (but this is more challenging to mount).

 

 

Useful documents

Coming soon!